Instructions for Assembly of Spinning Poles

If ornament is not on pole or if you wish to change ornament

1)     Securely grasp the 3-inch metal rod that protrudes from the bottom of the top half of the pole.

2)     Screw the ornament onto the top of the pole as far as it will go, being careful not to cross thread or over tighten.

To assemble top and bottom of pole together

1)     Locate notch in open end of lower section

2)     Slide 3-inch metal rod that protrudes from the top section into the bottom section, lining up screw with notch in bottom section.

3)     Press two sections of pole against each other until flush.

         CAUTION: Do not jam pole sections together

4)     Securely grasp the ornament on the top half of the pole with one hand and the bottom section of pole with the other hand and GENTLY turn bottom section in either direction, being careful not to over tighten.

5)     The two sections of the pole should now be locked and the top half of pole should spin freely.

To Mount Traditional Style Flag (heading and 2 grommets) on Pole

1)     Remove set -screws from flag fasteners, slip first fastener up bottom of flagpole and position just below swivel clip. Note: Swivel clip and snap hooks are not used with traditional style flag.

2)     Position opening in fastener under the top grommet of flag.

3)     Replace set- screw in fastener through grommet of flag thereby holding flag snug against pole.

4)     Repeat with lower grommet.

5)     Both grommets must be positioned above joint in order for pole to spin. Do not use oversize flags.

To Mount Banner Style Flag (Pole Sleeve) on Pole

1)     Slide pole through banner sleeve

2)     Locate pre-slit tab sewn inside top of banner sleeve

3)     Attach snap hook (on swivel clip) to pre-slit tab. Note: Flag fasteners are not used with banner style flags.

Caution: Spinning poles are not to be used with flags heavier than nylon

Flags should not be flown in extreme wind conditions

To Disassemble Spinning Pole

1)     Hold ornament firmly in one hand and bottom section of pole in the other hand.

2)     Line up small raised arrow on bottom section of pole with metal screw on joint.

3)     Gently pull sections apart. The two sections should come apart easily.

Caution: Do not use force. If top and bottom do not separate easily, repeat step 1 and turn pole slightly in either direction while pulling gently.

If you have Complete Set that Includes Bracket see below:

To Mount Flagpole to Building

1)     Mount bracket to building with screws supplied.

2)     Adjust bracket to desired angle and tighten wing nut to secure.

3)     Insert pole into bracket.

4)     Hand-tighten set screw to secure pole.